TacticalScope is a gaming community filled with Glitches, hacks and loads more and an all around great community
 
HomePortalCalendarGalleryFAQSearchMemberlistUsergroupsRegisterLog in

Share | 
 

 How to fix most xbox problems & Error codes

Go down 
AuthorMessage
TacticalScope
Admin
Admin


Posts : 91
Points : 2147614297
Reputation : 0
Join date : 2011-08-20

PostSubject: How to fix most xbox problems & Error codes   Sun Aug 21, 2011 10:03 pm

Dvd drive errors

Open tray

Method 1

[spoil]
[/spoil]


Method 2

[spoil][/spoil]

Method 3

[spoil]

Part 2



Part 3

[/spoil]

Method 4

[spoil][/spoil]

Method 5

[spoil][/spoil]

Jammed disk tray

Method 1

[spoil][/spoil]

Method 2

[spoil][/spoil]

Method 3

[spoil][/spoil]

All red ring of death errors & secondary error codes

E errors

[spoil]E45: Unknown (possibly dashboard update related)

E64: DVD Drive Error.... DVD Timeout, Wrong firmware, dvd is without f/w chip, etc.

E65: DVD Drive Error.... DVD Timeout, Wrong firmware, dvd is without f/w chip, etc. This can also be caused by the tray not being fully closed on boot.

E66: DVD Drive Error: DVD model, or version does not match that of the version expected by the dashboard. OR the firmware version on the drive is older then the firmware version expected by the dashboard. Make sure the DVD drive is of the same version originally included with the console and that it is using either the original firmware included with the console or newer.

E67: Hard Drive Error... It could be a problem with the Hard Drive itself or a problem with the internal connection to the hard drive, Try removing the hard drive and playing without it

E68: Hard Drive Error... It could be a problem with the Hard Drive itself or a problem with the internal connection to the hard drive, Try removing the hard drive and playing without it, This can also be caused by a Hard Drive Eprom Error. Some also believe this might be caused by a problem with the fans.

E69: Hard Drive Error... It could be a problem with the Hard Drive itself or a problem with the internal connection to the hard drive, Try removing the hard drive and playing without it

E71: possibly a dashboard update error, Check below in the "Console Reset Codes" for instructions. If that does not work there is no other solution and the console must be sent back to MS for repair.

E72: (not yet known)

E73: General Hardware Error: Ethernet port... this error is caused by a problem with the Ethernet port.

E74: AV cable error... There is a problem with the AV cable, try using a different AV cable. If the cable is known to be working then there is a 90% chance it's a scaler chip problem (the "ANA" or "HANA" chip connected directly to the AV cable) in rare cases it is the GPU.

E76: (not yet known)

E79: Hard Drive Error... It could be a problem with the Hard Drive itself or a problem with the internal connection to the hard drive, Try removing the hard drive and playing without it[/spoil]

Secondary error codes

[spoil]0001 power supply problem
0002 Network Interface problem
0003 Power problem could be the PSU could be the GPU/CPU, somehow the console isn't getting clean power from the power supply.
0010 over heating
0011 over heating - If you are receiving this error after disassembling your console make sure to all 8 of the heatsync screws are tightened securely to the board/heatsink holes.
0012 over heating
0013 over heating
0020 (Not yet known, possibly overheating)
0021 DVD Drive Time out - Can be caused by problems with a firmware flash. This is also speculated to sometime be caused by a problem with the southbridge chipset on the motherboard.
0022 GPU Error / GPU Overheating
0023 (not yet known)
0101 (not yet known)
0102 unknown error
though it's most likely GPU related literally means the console does not know what is wrong. possibly a short or cold solder joint somewhere. So far there is 1 major theory for what causes most of these errors is that the Ram, CPU, or GPU are not soldered properly to the mother board due either to poor manufacturing or excessive heat up and cool down cycles that stress, weaken and eventually break the soldered connection.
There are two theories to fixing this one deals with the "X" clamps that hold down the chips. The other involves re-Heating the chips. DO NOT attempt either of these if your console is still under warranty. If your console is still under warranty return it to the store where it was purchased or call MS to have it replaced. I have also heard of limited success by simply switching the AV cable from "HDTV" mode to "TV" mode.
0103 CPU Error/ CPU Overheating - see solution for error 0102
0110 Memory Error / Memory Overheating - see solution for error 0102
0200 (not yet known)
1000 (not yet known)
1001 (not yet known)
1002 (not yet known)
1003 Hard Drive Error... It could be a problem with the Hard Drive itself or a problem with the internal connection to the hard drive, Try removing the hard drive and playing without it
1010 Hard Drive Error, Can be caused buy a corrupt or missing eProm.
1011 (not yet known)
1012 (not yet known)
1013 (not yet known) possibly a dashboard update error
1020 (not yet known)
1021 (not yet known)
1022 AV cable error... There is a problem with the AV cable, try using a different AV cable. (could also be a problem with the encoder chip)
1023 DVD drive not connected, connect DVD drive to boot
1030 (not yet known)
1031 (not yet known)
1032 (not yet known)
1033 (not yet known)
1444 and up There is no "4" in the error codes four lights is a "0" go back and check your code again.[/spoil]

How to find your secondary error code

[spoil]turn the xbox 360 on, and wait till the 3 red lights are flashing.
Press and hold the sync up button (the small white one), while holding that button press the eject button.
The LEDs will now blink the first number in the code (as described below).
Release the eject button and press it again.
The LEDs will now blink the second number of the code.
Release the eject button and press it again.
The LEDs will now blink the third number of the code.
Release the eject button and press it again.
The LEDs will now blink the forth number of the code.
Release the eject button and press it again.
The LEDs will go back to the 3 red flashing lights.

[/spoil]

Here is how you interpret the LEDs to get the code number

[spoil]All four lights flashing - 0
One light flashing - 1
Two Lights flashing - 2
Three lights flashing - 3[/spoil]

How to fix 1 red light

[spoil][/spoil]

How to fix 2 red lights

[spoil]

Part 2



It might not work.[/spoil]

How to fix 3 red lights

[spoil][/spoil]

How to fix 4 red lights

[spoil]Make sure your AV cables are plugged in correctly, if they are try a different set[/spoil]

How to take your xbox apart

[spoil][/spoil]

How to fix xbox's when they dont turn on

[spoil]
[/spoil]

I take no credit for the videos

Back to top Go down
View user profile http://tacticalscope.bigforumpro.com
 
How to fix most xbox problems & Error codes
Back to top 
Page 1 of 1
 Similar topics
-
» Photobucket Problems
» DARKSEID BAF Problems...
» 2147287038 error, please help
» -2147287038 (Unspecified Error 0x80030002) I d/c after a few minutes of playing!
» Error message when gifting

Permissions in this forum:You cannot reply to topics in this forum
TacticalScope :: Xbox 360 :: Xbox 360 General Discussion-
Jump to: